CCS Fast charging
Remote programming for your Battery and motor (no need to send us your inverter)
Compatible with Tesla model 3/Y motor & battery (2018-2019-2020-2021-2022-2023)
Application for Android and IOS to access the data, change the limits and control the drive mode and PRND
100 % Waterproof and can be use for AWD, RWD and off grid application
Can be control wtih the App, by CAN bus or digital inputs
Low voltage harness included
Work with 2 batteries and more in parallel for off grid projects
If it comes from a salvage vehicle it may very strongly need to replace the pyro-fuse. You will need the charge port and a charge port ECU from the same car. You'll also need a high voltage connectors.
The 32A or 48A on-board charger (OBC) is functional and can be adjusted in amperage and percentage of charge. The DCDC 12 is also functional and can be fixed between 12-15V.
In the TM3 battery, there is no precharge relay or resistor. The Model 3 uses the 12V battery and the PCS to increase the battery voltage by 12V to match the pack voltage. The PCS becomes a key element in closing the pack's contactors. If there is a short circuit or if the capacitors of the equipment connected to the high voltage line are too large and take too long to charge the precharge will approach and the contactors will not close. It is important to do a precharge test with the battery and your equipment to confirm compatibility.
No, you have HV output for these. You are responsible for the thermal management, you need to have a controller that takes the cooling requirement from the motor or battery and handle it with your pumps and radiator.
If you have a problem or a question related to our controller, we'll help you. Unfortunately, we can't help you with your EV conversion and to build your system. We can't recommend you what to do or how to do your EV conversion.
Yes! Also, if you use the 980 rear motor, we can add 150 HP to it. Contact us for more information.
Yes! We have a large inventory of used EV parts.
By purchasing our controller, we program remotely your inverter, oil pump, and battery free of charge.
You’ll need: - Team Viewer - Pcan connected (provided with the battery controller) - A PC with Windows 10 - A good internet connection of at least 30 Mbps internet as well as a wired internet access What you need to prepare: - A 12 Volt must be connected to the 2 studs of the battery with booster cables. - All battery cover bolts must be torqued - The battery must be intact (Not disassembled) - Cabin heater and A/C connector need to have the HVIL loop connected - Both HV output for the motors on the battery pack will have HV connector (with HVIL loop) connected.
Yes, if it is this model (You must have this model): [Link to PCAN Model](https://www.peak-system.com/PCAN-USB.199.0.html?&L=1)
Yes, our system can control several batteries. Contact us for more info!
Yes, our controller supports the 2018-2019-2022-2021-2022-2023 motor and battery.
The Ingenext app:
- Compatible with Android and IOS.
- Data display
- Control the drive mode and PRND
- Set the limits
- Customizable according to your needs
*You need to buy this OBDlink: [Link to OBDlink](https://www.obdlink.com/products/obdlink-mxp/) / [Amazon Link](https://www.amazon.com/OBDLink-Bluetooth-Professional-Grade-Diagnostic-Performance/dp/B07JFRFJG6)